On Friday, February 27, 2004 11:45 AM
Andreas Bublitz
I solved the problem. Even though Mercury only allows relaying if you have the right credentials, it works if I leave user and pass blank. If I put in the right data, i get the error: smtp authentication failed. Gosh, these computers just drive me mad.
Reread the section in Mercury's manual about possible combinations and steps of authentication levels. Yes, it's somewhat irritating, but in the end straight forward. Erm... ok, in the *very* end. ;)
To enable debugging output, set $Self->{Debug} to something higher than 1.
I enabled Debug in my Config.pm file, but it still get the same output. Strange.
So it might the module has no extended output to serve, or you might try enabling $Self->{Debug} = 9; in the source code of the module itself AND in Config.pm. hth, Robert Kehl -- ((otrs.de)) :: OTRS GmbH :: Norsk-Data-Str. 1 :: 61352 Bad Homburg http://www.otrs.de/ :: Tel. +49 (0)6172 4832388